How To Install Starter Shingles Video
The main reason for a starter course is to fill the gaps between the keys on the shingles. It’s easy for a single person to position starter strip shingle on the roof.
Then continue across the roof.
How to install starter shingles video. One of the most common sources of failure in a roof system is the improper. A superior alternative to starter shingles. Many pros shingle in a vertical line up the roof because it’s much faster.
Remember in high wind areas install a leak barrier along the rakes for added protection, and install starter shingles up the rake. One of the most common sources of failure in a roof system is the improper. A superior alternative to starter shin.
Tom melillo, residential project manager, roof services: Move left to right or right to left, but not straight up the roof in a rack. Lower edge of the roofline and nailing them down using roofing nails.
Place the second shingle next to the first. Begin your shingle installation by laying a row of starter shingles along the. Simply apply a single course of starter shingle roll along a clean, dry and smooth eave line or rake edge, after removing the release sheet.
Starter shingle roll eliminates the need for cutting shingle tabs or inverting them to create a starter row, saving installation time. Application is a snap too. With the starter shingles laid along the very edge of the roof, run a set of starter shingles along the sides of the roof as well, making sure that those rows come down and overlap the starter.
Apply the first shingle over the starter strip at. A superior alternative to starter shingles. Place the shingle so that it is flush with the starter course with the start course over hanging the eave or drip edge by 1/4” to 3/4”.
Speeds installation and helps improve safety. Starter strips are important for wind resistance. If you don't have a starter strip, refer to the figure to see how you can make you own from the shingles.
To 3⁄4 in.—or even 1 in. Starter strip shingle eliminates the need to cut off tabs or headlap. Remember in high wind areas install a leak barrier along the rakes.
Snap a chalk line in the center of the roof. Starter strips are important for wind resistance. Use with any shingle that has an exposure of up to 6.
Shingle installation begins with starter shingles that are installed along the eave and rake edges. If bowing eaves or rake boards require it. Use weatherblocker or prostart starter strips.
Place the shingle so that it is flush with the starter course with the start course over hanging the eave or drip edge by 1/4” to 3/4”. Use weatherblocker or prostart starter strips.
0 Response to "How To Install Starter Shingles Video"
Post a Comment